Set base plate down and set 2×4 tube over bolt flanges. Attach Base plate to 2×4 tube with supplied 3/8 x 4″ bolt using 9/16″ wrenches. Pic (1) 2. Tighten bolt until snug. (note: tube will still have some side to side movement, ground will hold it upright when buried.)...
Read more
A standard 3-6ft tall 2×4 board (not included) and 4 pieces of ¾”x4-5ft electrical conduit (not included) are required to complete this assembly. Conduit can usually be found at your local hardware store for a few dollars. 1. Slide each piece of ¾” conduit onto the 2×4-conduit connectors in pic (1)...
Read more
A standard 3-6ft tall 2×4 board (not included) is required to complete this assembly. 1. Fasten two legs together by putting tabs into set of holes farthest from tabbed end on other leg. Pic (1) 2. Insert 3rd leg tabs into 2nd leg’s set of holes closest to tabbed end to start creating a...
Read more
1. Insert carriage bolt into target front to back.Install washer over bolt on backside of target. Pic (1) 2. Install ½” regular nut leaving room between target and washer for room for mount. Tighten until the target barely touches the very top edge of the mount so target can move. Pic (2)...
Read more
A standard metal fence t-post (not included) is required to complete this assembly. 1. Insert mount over the top of a standard t-post. 2. Ensure the bolts face the flat part of the t-post. 3. Tighten the two 5/16” bolts (included) until the mount is firm. 4. Install a ½ inch x 2″ carriage...
Read more
A standard 3-6ft tall 2×4 wooden board (not included) is required to assemble your stand, in addition to the mount kit components. 1. Insert mount over the top of a standard 2×4 board. It should fit snugly. (Pic 1) 2. Install a ½ inch x 2″ carriage bolt and lock nut into...
Read more
Hostage Target Instructions Thank you for purchasing your hostage target assembly. It will only take a few minutes to assemble and the only tool needed is a 1/2″ wrench. 1. Flip 2×4 /t-post mount upside down (pic1). Insert supplied 3/8″x1 1/4″ carriage bolts through holes. 2. Carefully slide hostage target...
Read more