2×4 X-Base Assembly

A standard 3-6ft tall 2×4 board (not included) is required to complete this assembly. Brand new inexpensive construction lumber works the best.

1. Unpackage 2×4 tube, four legs and two 3/8 carriage bolts with wingnuts. Pic (1)

2. Over lap legs on each side so bolt holes in legs and the 2×4 tube line up. Pic ( 2)

3. Insert included 3/8″ inch carriage bolts through leg holes and tube holes. Install wingnuts. Pic (3)

4. The completed base will look like pic 4. Slide 2×4 into hole and install top mount. Wood 2×4’s can slightly vary in size as they pick up moisture overtime. Brand new 2×4’s can have a slight bit of slop, which is common. If a tighter 2×4 fit is preferred, soak end of 2×4 in water for 5 minutes and it will slightly swell up and keep its shape.