2x4 mount assembly

2×4 Mount Kit Assembly

A standard 3-6ft tall 2×4 wooden board (not included) is required to assemble your stand, in addition to the mount kit components.

1. Insert 2×4 mount over the top of a standard 2×4 board. It should fit snugly. (Pic 1)

2x4 Mount kit assembly - Pic 1

2. Install a ½ inch x 2″ carriage bolt and lock nut into your target.

3. Tighten until the target barely touches the very top edge of the 2×4 mount so target can move as in picture. Do not over tighten. Target should move freely. Silhouettes should be 1 to 1 1/2 inches from 2×4 when properly mounted.

2x4 Mount kit assembly - Pic 2
Posted in

wpengine

This is the "wpengine" admin user that our staff uses to gain access to your admin area to provide support and troubleshooting. It can only be accessed by a button in our secure log that auto generates a password and dumps that password after the staff member has logged in. We have taken extreme measures to ensure that our own user is not going to be misused to harm any of our clients sites.